Two stereo input channel strips, each comprise two independent pairs of inputs.

Connector Bay (behind meterbridge)

Both pairs of line inputs are balanced. Plugging in the left jack only will feed a mono source to both paths.

Cassette/CD Input Section

This features two gain settings: LO for -10dBV semi-pro devices such as CD or cassette players, or HI for -20dBV hi-fi equipment. Signals are controlled by the LEVEL TO MIX pot and directed straight to Mix. The input can be soloed pre-fader, with two pre-fade auxes allowing the signal to be sent to stage monitor mixes.

Stereo Input Section

A gain control operates from 0 to 22dB allowing the connection of line level devices as well as most professional and hi-fi sources.

EQ Section

A two band frequency switchable EQ provides 15dB of cut or boost over high or low frequencies. The HF control is selectable between 6 or 12kHz, with LF selectable between 80 and 120Hz.

EQ In/Out Switch

This switch allows comparison of treated and untreated sounds.

Aux Section

The Stereo Input has 6 Auxiliaries with identical pre/post-fader settings to the mono inputs.

Balance

This control sets the amount of signal feeding the left and right mix outputs and the odd or even groups. Acts as a Pan control when a mono signal is used.

PFL/Solo

Pressing the PFL switch provides a mono sum solo of the pre-fade, post- EQ signal.

Fader/Route/Muting Switch

The fader, mute switch and routing switch behave identically to the mono channels.